Technical Specifications:
Water/plaster factor required for mortar: 7-7,5 / 10
Powdery specific bulk density: 800 Kg/m3
Period in plastic consistency : 8-10 minutes
Explication of the product:
It is a gypsum plaster which is used for the purpose of decorative
such as plasterboard indoors.
It forms a rubbed casting surface.
It has high strength.
It is a high quality material which is produced according to TS EN
13 279-1/TS EN 13 279/2 standards.
Instructions for application:
After 7-7,5 liter water is putted into large and clean plastic cape,
10kg decorative plaster
spills into water. It is waited for a few minutes. Mortar is mixed
with a trowel or a clean mixing device. After a homogeneous mixture
is achieved, the mortar is casted in mold. After the mortar is
prepared, any water or plaster must not be added.
To perform a good application, one must ensure that there is no dirt,
dust on mold, mold surface must be oiled properly.
By reducing water rate, higher strength is obtained.
If you want to share with our website ;
