Technical Specifications:
Water/plaster factor required for mortar:6-6,5 / 10
Powdery specific bulk density:800-850 Kg/m3
Period in plastic consistency :60 minutes
Amount of consumption: 10kg/m2 for 1 cm thickness
Explication of the product :
It is an ideal construction site material for plastering of wall and ceiling surfaces and repairing of cracks indoors.
It does not create any cracking.
It can be applied to all kinds of surfaces.
It creates an ideal primer for application of top coat satin application.
It is produced according to TS EN 13 279-1/TS EN 13 279/2 standards, it is a high quality material.
Instructions for application:
After 6-6.5 liter water is putted into large and clean plastic cape, 10kg gypsum plaster spills into water. It is waited for a few minutes. Mortar is mixed with a trowel or a clean mixing device. After the mortar is completed, any water or plaster must not be added. Prepared mortar is used minimum 60 minutes. The application surface must be cleared of oil and dust. Also, overheat surfaces are required to be wet by spilling water.
By taking from prepared mortar, it spreads to wall properly with steel trowel. The mortar is plastered roughly without not more much suppressing and its redundant is taken by stripping. If surface voids are occurred, first plastering activity is completed by filling. Possible traces and roughness are cleaned with steel trowel after hardening of mortar is waited.
If you want to share with our website ;
