Technical Specifications:
Water/plaster factor required for mortar:6.5-7/10
Powdery specific bulk density:700kg /m3
Period in plastic consistency :1.5 hours
Amount of consumption: 1kg/m2 for 1 mm thickness
Explication of the product:
It is finish plaster mix for intern sites. It is ideal construction
site material for bringing final shape of walls and ceiling surfaces
and for preparing appreciate floor to wall paper.
It does not create any cracking.
It can be applied to all kinds of surfaces.
It is produced according to TS EN 13 279-1/TS EN 13 279/2 standards,
it is a high quality material.
Application Instructions:
After 6.5-7 liter water is putted into large and clean plastic cape,
10kg satin finish plaster spills into water. It is waited for a
few minutes. Mortar is mixed with a trowel or a clean mixing device.
After the mortar is completed, any water or plaster must not be
added. Prepared mortar is used minimum 80-90 minutes. The
application surface must be cleared of oil and dust. Also, overheat
surfaces are required to be wet by spilling water.
By taking from prepared mortar, it spreads to wall properly with
steel trowel. Finishing activities are made on wall with upward/
downward and right/left strippings, dually, and not create thickness
and not leaving traces of steel trowel must be also considered.
Possible traces are cleaned with steel trowel after hardening of
mortar is waited.
If you want to share with our website ;
